Ghost 2 Immobiliser Problems The Ghost 2 immobiliser, designed to safeguard cars from key cloning or hacking, is a discrete device that can be installed without damaging your vehicle. It stops you from starting your car unless you enter the correct sequence of buttons in your vehicle. It is similar to the mobile password. Stop/Start Ghost Immobilisers protect vehicles from being stolen by preventing the engine from starting until it has the correct PIN code. This is done without modification to the vehicle and is totally undetectable to thieves. The unit communicates with the ECU on the CAN data bus to immobilise the vehicle. This system is very like the one automobile manufacturers have used in their vehicles for a long time, however, the thief cannot add a new key or use key relay technology to bypass it like they can with factory fitted systems. Ghost is compatible with any vehicle with an engine, including cars, vans, motorhomes and caravans, as well as bikes. The same system can be used on electric vehicles. It is an excellent alternative to steering wheel locks and wheel clamps and can be installed with little effort. When the Ghost is activated, it will block all the buttons in your vehicle and prevent the ignition from starting until a PIN code has been entered first. This can be done via the Android or Apple mobile apps or by entering the code using your key fob. If the wrong code is entered, the app will show an indicator light and the Ghost will not allow the vehicle to start again. This is a great way to deter thieves. If the vehicle cannot be started and they are unable to get it started, they will leave. The Ghost is a weatherproof, small device that can be tucked behind the most difficult-to-access areas of your vehicle. It is incredibly easy to install with an average of 20-30 minutes per vehicle. It is also very simple to remove should you choose to change your vehicle or hand it in for service or valet parking. It is a TASSA (Tracking and Aftermarket Security Systems Association) insurance approved system that is endorsed by some insurers. It also has an emergency Pin Code override and features a Service/Valet mode that can be activated with an app button or by using your key fob. Disarm Ghost immobilisers are not mechanical anti-theft devices that are able to be removed, are hidden in the car. Even if they were found and stolen, thieves would not be able start the car. They are virtually impossible to hack or bypass. This is because a ghost immobiliser prevents key hacking, signal jamming and device spoofing - methods that are frequently used by thieves to get into vehicles with standard immobilisers. An immobiliser operates by sending an electronic code to the ECU (electronic control unit). If a wrong code has been received, the vehicle will not start because the engine will not fire up. While it is possible to disable the ghost immobiliser using a software tool it is laborious and time-consuming. The software can only be installed and used by a authorised installer. The Ghost immobiliser is a small system that sits within the wiring loom of the vehicle and is inaccessible to the naked eye once installed. It does not appear on diagnostic systems. There are no indicators with LEDs, and it doesn't communicate with the engine via the OBD port. It communicates in silence via the CAN data loop. The system will stop the vehicle from starting unless it receives a user defined PIN code sequence. This is entered through buttons on the steering wheel or door panels, or on the centre console. This is a better way to protect the car, because it doesn't need an additional remote control or key fob. Ghost also has a service mode that can be turned on via the mobile application. This lets you hand over your keys to someone else for service or valet parking, without the need to enter the disarm sequence. Whether your Ghost is in service mode or not you should not attempt to remove the system by yourself as it can affect your engine and cause damage. It is recommended to contact an TASSA verified installer who can remove the system safely and correctly. Our latest GHOST immobilisers come with a unique fingerprint QR sticker, which is hidden in various parts of your vehicle. These are linked to our security register. In the event that the system is removed and then sold on the black market it will be able to trace the owner of the system. Anti-Hijack The anti-hijack function is an essential feature of the Ghost Immobiliser 2. It functions like an intelligent key and is among the most secure methods to protect your vehicle from theft. The Ghost system will automatically activate the hazard light and stall the car's engine when the ignition is turned on and the vehicle is stationary. This allows the driver and passengers enough time to press the secure button before the system can be activated. In contrast to other systems that simply stop the engine once the ignition is switched on and on, the Ghost system uses a special controller and timer that will shut off the fuel cut-off valve 14 when it is activated after a set period of time even when the ignition is in operation! This delay time period must be sufficiently long to allow the victim of the vehicle to drive away from the site of the robbery and sufficient distance from the vehicle in which it is stuck before the system is able to reactivate. In addition to the standard CANbus immobiliser blocking features of the Ghost system, it comes with an extra security level that blocks common hacking methods that are used to hack into modern cars such as relay attacks, key range extending and ECU swapping. The Ghost system communicates in a non-intrusive way and does not emit signals that could be snatched by thieves with code-grabbing technology or RF scanning. The Ghost system also has the option of a Service/Valet mode that allows your vehicle to be started temporarily and driven without the need for PIN codes. This is ideal for parking your vehicle and have to be away for a short period of time, such as for instance, to put your groceries in the boot or open a garage door, etc. The system will end the service mode according to the speed and duration or by a simple PIN code input process. This will give you complete peace-of-mind that only YOU can drive your vehicle! Keyless Entry Many customers are now looking for extra security measures because of the rising trend of contactless car theft. This is particularly true for those who invested time and money in customizing their vehicles or own expensive automobiles. An immobiliser add-on can be an effective way to avoid this kind of theft because it can prevent your vehicle from starting unless the correct pin code is entered on your key fob. Immobilisers are made to work with different vehicle circuits, including ones which control starter motors and fuel pumps. They can also turn off the car alarm in order to draw attention and scare away potential thieves. These devices communicate with the engine control unit (ECU) through the CAN data circuit. They also they stop the thief trying to get around it by installing a brand new ECU or by using an engine key programmer. The immobilisers can be installed in a discreet manner inside your vehicle, leaving no trace and are totally undetectable by the tools that sophisticated thieves use. The Ghost immobiliser is different from other systems which require the driver to carry an app or tag. Instead, you can choose your personal pin sequence by pressing the pattern on your steering wheel, door panel, and the centre console. The pin can be easily changed to make the device as secure as a bank card. It's also more difficult to hack because it requires up to 20 presses. Ghost also has a Valet/Service mode that lets you deactivate the system if your car is going to be handed over for valet parking or service and allows it to operate within predetermined guidelines, such as a 30mph speed limit, so you don't have to worry about your car being driven at a reckless speed. It is then reactivated with the original key or key that corresponds to the entry code. This makes it the most efficient and secure aftermarket CAN-based immobiliser on the market and is fully insurance-approved by Thatcham as an add-on for your car when installed by one of our authorised installers. The Ghost 2 immobiliser comes with six QR fingerprint labels as well as an ISR contact cards containing your unique QR codes, along with an emergency code that is safe. cost of ghost immobiliser are all stored in your purse or wallet.
cost of ghost immobiliser
